HD Radio Tuner Instruction Manual

En-14
Listening to AM and FM Radio
Tuning into weak stereo FM stations
If the signal from a stereo FM station is weak, it may
be impossible to get good reception. In this case,
switch to Manual Tuning mode and listen to the sta-
tion in mono.
1. Turn on your Universal Port-compatible
Onkyo product and select the PORT input
source.
2. Press the [PORT] remote mode button on
your remote controller to select the PORT
remote mode.
3. Press the Play [ ] button repeatedly to
select AM or FM.
4. Press the [PLAY MODE] button repeatedly
to select Auto or Manual Tuning mode.
•Auto Tuning Mode
The AUTO indicator appears and stereo radio
reception is possible.
• Manual Tuning Mode
The AUTO indicator disappears and radio recep-
tion will be in mono.
5. Use the [ ]/[ ] buttons to tune into a
station.
In Auto Tuning mode, once a station is found, tun-
ing stops automatically.
FM frequency changes in 0.2 MHz steps, 10 kHz
steps for AM.
In Manual Tuning mode, the frequency stops
changing when you release the buttons. Press the
buttons repeatedly to change the frequency one
step at a time.
When tuned into a station, the Tuned indicator on
your Universal Port-compatible Onkyo product
appears.
When tuned into a stereo FM station, the FM STE-
REO indicator on your Universal Port-compatible
Onkyo product appears.
The FM STEREO indicator shows the status of ana-
log audio. (It does not indicate the status during
digital reception.)