Owner's Manual
20
Connecting Your Speakers
—Continued
Use the center speaker base to mount the center speaker
horizontally. If you place the speaker and its base on top
of a TV or an entertainment center, adjust the angle of
the speaker so that it faces toward the listening position.
The center speaker should be installed on the base
securely. If the speaker is loose, try adjusting the position
so that it sits securely on the base.
The cradle surface of the base features two stoppers to
prevent the speaker from moving. Therefore, you can tilt
the speaker toward the front by up to 15 degrees.
■
Using the included rubber spacers
We recommend using the supplied rubber spacers to
achieve the best possible sound from your speakers.
The rubber spacers prevent the speakers from moving,
providing a more stable setup.
The speakers can easily be wall mounted by using the
keyhole slots. To prevent the speaker from vibrating
against the wall, attach four of the supplied rubber spac-
ers to the rear of each speaker.
■
Mounting vertically
To mount the speakers vertically, use the one keyhole
slot shown to hang each speaker on the screw that is
securely screwed into the wall.
■
Mounting horizontally
To mount the speakers horizontally, use the two keyhole
slots shown to hang each speaker on two screws that are
securely screwed into the wall.
Caution:
A mounting screw’s ability to support a speaker depends
on how well it’s anchored to the wall. If you have hollow
walls, screw each mounting screw into a stud. If there are
no studs, or the walls are solid, use suitable wall anchors.
Use screws with a head diameter of 3/8" or less and a
shank diameter of 1/8" or less. With hollow walls, use a
cable/pipe detector to check for any power cables or
water pipes before making any holes.
Leave a gap of between 1/4"
and 5/16" between the wall and
the base of the screw head, as
shown.
(We recommend that you con-
sult a home installation profes-
sional.)
Center Speaker Base
15
SKC-645C
Stoppers
Base for horizontal
mounting
Rubber spacer
Bottom of the
base
Wall Mounting
Rubber spacer
Keyhole slot for
wall mounting
Rubber spacer
Keyhole slot for wall mounting
Wall
1/4" – 5/16"
HT-SR750_En.book Page 20 Thursday, August 2, 2007 10:05 AM