Instruction Manual

47
Common Functions —Continued
With this function, you can temporarily mute the output
of the AV receiver.
To unmute the AV receiver, press the remote control-
ler’s [MUTING] button again, or adjust the volume. The
output is unmuted and the MUTING indicator goes off.
Muting is cancelled when the AV receiver is set to
Standby.
With the sleep timer, you can set the AV receiver so that
it automatically turns off after a set period.
To cancel the sleep timer, press the [SLEEP] button
repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time, press the [SLEEP]
button. Note that if you press the [SLEEP] button while
the sleep time is being displayed, you’ll shorten the sleep
time by 10 minutes.
Muting the AV Receiver
Press the remote controller’s
[MUTING] button.
The output is muted
and the MUTING
indicator flashes on
the display, as shown.
MUTING
PREVIOUS
MENU
GUIDE
TOP MENU
SP A / B
SETUPRETURN
PLAYLIST PLAYLIST
RANDOM SUBTITLE
PLAY MODE
AUDIO REPEAT
RC
-
645S
--
/
---
TAPE
ON/STANDBY
DIMMER SLEEP
INPUT SELECTOR
REMOTE MODE
V 1 V 2 V 3
C DTAPE TUNER
DVD
MULTI CH
LISTENING MODE
DISPLAY
TEST TONE CH SEL
SURROUND STEREO
CINE FLTR
LEVEL
+
LEVEL
-
L NIGHT
VOL
HDD
CDR
MD
DVD
RECEIVER
C D
+
10
0
CLR
123
456
789
ENTER
CH
DISC
ALBUM
MUTING
SLEEP
Press
[RECEIVER]
first
MUTING
Remote
controller
Using the Sleep Timer
Press the remote controller’s
[SLEEP] button repeatedly to
select the required sleep time.
You can set the sleep time from 90 to 10
minutes in 10 minute steps.
The SLEEP indicator appears on the
display when the sleep timer has been
set, as shown. The specified sleep time
appears on the display for about five
seconds, then the previous display
reappears.
SLEEP
Remote
controller
SLEEP indicator
HT-S4100_En.book Page 47 Friday, February 22, 2008 2:15 PM