Instruction Manual

42
Using the Tuner
With the built-in tuner, you can enjoy AM and FM radio
stations. You can store your favorite stations as presets
for quick selection.
■ Auto Tuning Mode
■ Manual Tuning Mode
FM frequency in 0.2 MHz steps, 10 kHz steps for AM.
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator appears on the display, as shown.
Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Note:
•You can also use the remote controller’s Up and Down
[ ]/[ ] buttons to tune the radio.
Listening to the Radio
1
Use the [TUNER] input selector
button to select either AM or FM.
In this example, FM has been selected.
(Actual display depends on country.)
TONE
+
STEREO
LISTENING MODE DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE
RETURN
TUNING / PRESET
ENTER
SETUP
STANDBY
STANDBY/ON
CLEAR
PHONES
MULTl CH DVD VIDEO 1/VCR VIDEO 2 VIDEO 3 TAPE TUNER CD
MASTER VOLUME
A SPEAKERS B
TUNING
TUNER
SETUP
TUNING MODE
TUNER
Band Frequency
Tuning into Radio Stations
1
Press the [TUNING MODE] button
so that the AUTO indicator
appears on the display.
2
Press the TUNING Up or Down
[ ]/[ ] button.
Searching stops when a station is
found.
1
Press the [TUNING MODE] button
so that the AUTO indicator disap-
pears from the display.
2
Press and hold the TUNING Up or
Down [ ]/[ ] button.
The frequency stops changing when
you release the button.
Press the buttons repeatedly to change
the frequency one step at a time.
TUNING MODE
TUNING / PRESET
ENTER
TUNING MODE
TUNING / PRESET
ENTER
AUTOTUNED
FM STEREO
HT-S4100_En.book Page 42 Friday, February 22, 2008 2:15 PM