Owner's Manual

Installing the remote controller batteries

1. Remove the battery compartment cover by pressing and

sliding it away from the remote controller unit.

2. Insert two AA (R6- or UM-3)-size batteries into the battery

compartment. Carefully follow the polarity diagram

(positive (+) and negative (–) symbols) inside the battery

compartment.

3. After batteries are installed and seated correctly, replace the

compartment cover.

Notes:

• Do not mix new batteries with old batteries or different kinds of

batteries.

• To avoid corrosion, remove the batteries if the remote controller

is not to be used for a long time.

• Remove dead batteries immediately to avoid damage from

corrosion. If the remote controller doesn’t operate smoothly,

replace both the batteries at the same time.

• The life of the batteries supplied is about six months but this

will vary depending on usage.

Using the remote controller

Point the remote controller toward the remote control sensor.

Notes:

• Place the unit away from strong light such as direct sunlight or

inverted fluorescent light which can prevent proper operation of

the remote controller.

• Using another remote controller of the same type in the same

room or using the unit near equipment which uses infrared rays

may cause operational interference.

• Do not put any object such as a book on the remote controller.

The buttons of the remote controller may be pressed by mistake

and drain the batteries.

• Make sure the audio rack doors do not have colored glass.

Placing the unit behind such doors may prevent proper remote

controller operation.

• If there is any obstacle between the remote controller and the

remote control sensor, the remote controller will not operate.

Preparing the Remote Controller

DV-C601

Remote control sensor

approx. 5 m

(16 feet)