Owner's Manual

bf ;~od . and are therefore
atures 1tn(i bn!Jlldi:ty: J}o . not nse .
i:rect sunlight or in huffiid places,
toner;
hurriidifier;:bathioom, or
Woofer
Grille
attachment
catcher
[J
Grille
The two speakers are identical, so it doesn't matter which one you use on
the left or right.
I Using Close to a TV or Computer
TVs and computer monitors are magnetically sensitive devices and as such
are likely to suffer from discoloration or picture distortion when
conventional speakers are placed nearby. Note that discoloration can also
be caused by a magnet
or demagnetizing tool that's too close to your TV or
monitor.
I Removing the Grilles
]~ ]/.
Remove Replace
2
I Using the Cork Spacers ~
Cork spacer~, A~
. ~Q J
~~
Bottom ~ ·'
I Connecting the Speakers
• Before connecting the speakers, disconnect your amplifier's power cord
from the wall outlet and set its volume control to minimum.
•
The speaker's rated impedance is 4 Q Make sure you connect an
amplifier that
is compatible with a 4 n impedance.
• Use the supplied speaker cables to connect the speakers to your amplifier
as shown.
==c ( 7c:::D
..
~ A "
~
..
~"" f21 '
~
1. Peel the 2. Loosen the terminal
3. Fasten the
insulation
off screw and insert the terminal
the
ends of the speaker cable into the screw.
speaker cable hole (until the core
and twist the
wires
are inserted
core wires.
fully).
Right speaker
Speaker cable
The type of speaker terminals used on the receiver and their position
depends
on the model. Refer to the receiver's instruction manual for details
on connecting speakers to the receiver.
• Make sure the speaker's
positive(+) terminals are
connected to the amplifier's positive (+)terminals, and
the speaker's
negative(-) terminals are connected to
the amplifier's
negative( - ) terminals.
•
Make sure that the positive(+) and negative( - ) wires
are not touching each other.
If they are, a short circuit
may
occur , damaging your amplifier.
I care
To maintain the appearance of the speakers, you should periodically wipe
them with a soft, dry cloth. Do not use abrasive cloths, thinners, alcohol,
or
other solvents that may damage the finish.
I Specifications
Type:
Impedance:
Maximum input power:
Output sound pressure level:
Frequency response:
Crossover frequency:
Cabinet capacity:
Dimensions (W
x H x D):
Weight:
2-way bass reflex
4n
70W
83 dB/W/m
55Hz-35kHz
2.5 kHz
5.7
i
154 x 245 x 258 mm
(incl. grille and projection)
3.6 kg
Speakers
Woofer:
12 em N-OMF cone type
Tweeter: 2.5
em Soft Dome type
Terminal:
Grille:
Accessories:
Other:
Binding post (Banana type supported)
Detachable
1.8 meter speaker cable x 2
Cork spacer x 8
Non-magnetic shielding
Specifications and appearance are subject to change for improvement without prior
notice.