User Manual

14
> Network Functions > Specifications > Advanced Setup > Listening Modes
Troubleshooting Supplementary Information, etc�|
> Basic Manual
Setting Item Default Value Setting Details
Center 0 dB After selecting the speaker frequency from
between "25 Hz" and "16 kHz" with the cursors
/
, adjust the volume of that frequency between
"−6 dB" and "＋6 dB" with
/ .
Height 0 dB After selecting the speaker frequency from
between "25 Hz" and "16 kHz" with the cursors
/
, adjust the volume of that frequency between
"−6 dB" and "＋6 dB" with
/ .
Surround 0 dB After selecting the speaker frequency from
between "25 Hz" and "16 kHz" with the cursors
/
, adjust the volume of that frequency between
"−6 dB" and "＋6 dB" with
/ .
Surround Back 0 dB After selecting the speaker frequency from
between "25 Hz" and "16 kHz" with the cursors
/
, adjust the volume of that frequency between
"−6 dB" and "＋6 dB" with
/ .
Subwoofer 0 dB After selecting the speaker frequency from
between "25 Hz" and "160 Hz" with the cursors
/
, adjust the volume of that frequency between
"−6 dB" and "＋6 dB" with
/ .
•
This cannot be selected if "No" is set in
"Configuration" - "Subwoofer".
•
The result may not be as expected depending on the input source and listening mode setting.
3� Audio Adjust
Make advanced settings such as those related to multiplex audio, settings for the LFE level,
or those related to the volume of this unit.
■ 1� Multiplex/Mono
Setting Item Default Value Setting Details
Multiplex Input
Channel
Main Set the audio channel or language to be output
when playing multiplex audio or multilingual TV
broadcasts etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels will be output
at the same time.
•
If multiplex audio is being played, "1＋1" will be
displayed when
on the remote controller is
pressed.
Mono Input
Channel
Left + Right Set the input channel to use for playing any 2 ch
digital source such as Dolby Digital, or 2 ch analog/
PCM source in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right" : Left and right channels
■ 2� Dolby
Setting Item Default Value Setting Details
Loudness
Management
On When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume of
dialog at a certain level. Note that when this setting
is Off, the Late Night function that allows you to
enjoy surround at low volumes is fixed to off when
playing Dolby Digital Plus/Dolby TrueHD.
"On": When this function is to be used
"Off": When this function is not to be used