Owner's Manual

SN 29344352
I0607-1
(C) Copyright 2006 ONKYO CORPORATION Japan. All rights reserved.
* 2 9 3 4 4 3 5 2 *
Attach the additional top panel to the original
top panel by inserting and tightening the addi-
tional top panel screws in the appropriate screw
holes in accordance with the size of the speaker.
Insert the spikes into the spike holes in the base.
Onkyo recommends that you use the included
spikes for improved sound quality. However, be
aware that spikes may leave scratches or traces on
a wooden floor.
Secure the D-312E speaker to the stand.
Use the speaker affixing screws and teflon washers
to install and secure the speaker to the stand, as
shown in the illustration.
Assembling the speaker stand
Maintenance
To keep the stand clean, occasionally wipe off
dust using a soft dry cloth.
To remove dirt, dilute a neutral detergent (e.g., a
6-to-1 water/detergent solution). Lightly dampen
a cloth using the diluted detergent solution, then
wipe off the dirt. Then, wipe off any detergent
from the surface using a water-soaked cloth.
Finally, wipe the surface using a soft dry cloth.
Do NOT use alcohol or a thinner solvent or allow
the surface to remain wet. Otherwise, the stand
may be deformed or discolored.
AS-1E.fm Page 2 Thursday, July 20, 2006 10:40 AM