user manual
Table Of Contents
- Safety Information and Introduction
- Connections
- Turning On & Basic Operations
- Playback
- Playback
- Controlling Contents of USB or Network Devices
- Understanding Icons on the Display
- Playing an Audio from Bluetooth-enabled Device
- Playing a USB Device
- Listening to TuneIn
- Registering Other Internet Radio
- Changing the Icon Layout on the Network Service Screen
- Playing Music Files on a Server (DLNA)
- Playing Music Files on a Shared Folder
- Remote Playback
- Listening to AM/FM Radio
- Playing Audio and Video from Separate Sources
- Using the Listening Modes
- Displaying Source Information
- Using the Sleep Timer
- Setting the Display Brightness
- Changing the Input Display
- Muting the AV Receiver
- Using the Whole House Mode
- Using the Home Menu
- Playback
- Advanced Operations
- Controlling Other Components
- Controlling Other Components
- Preprogrammed Remote Control Codes
- Looking up for Remote Control Codes
- Entering Remote Control Codes
- Remapping Colored Buttons
- Remote Control Codes for Onkyo Components Connected via RI
- Resetting the REMOTE MODE Buttons
- Resetting the Remote Controller
- Controlling Other Components
- Using the Onkyo Dock
- Controlling Your iPod/iPhone
- Controlling Other Components
- Appendix
- Internet Radio Guide
- Remote Control Codes
Playback
En-47
Note
*1
(North American and Taiwanese models) This listening mode is not available.
*2
Pure Audio cannot be selected when Zone 2/3 is active.
Besides, if you activate Zone 2/3 while Pure Audio is selected, the listening mode will
automatically switch to Direct.
*3
Based on the audio channel signal contained in the source, the corresponding speakers
will output the sound.
*4
The AV receiver can input the DSD signal from HDMI IN. Depending on the player,
setting the output on the player side to PCM might bring better sound.
*5
For the Blu-ray Discs, Dolby Digital is used in a 3.1/5.1-channel speaker system.
*6
DTS is used depending on the configuration of the AV receiver.
*7
If there are no surround back speakers, DTS is used.
*8
If there are no surround back speakers, Dolby Pro Logic II is used.
*9
This listening mode can be selected only when all the following conditions are satisfied:
– Center speaker is connected.
– Front high speakers is connected.
• THX Surround EX
This mode expands 5.1-channel
sources for 6.1/7.1- channel playback.
It’s especially suited to Dolby Digital EX
sources. THX Surround EX, also
known as Dolby Digital Surround EX, is
a joint development between Dolby
Laboratories and THX Ltd.
D
H
V
Listening Mode Description Input
Source
Speaker
Layout
THX Su r r EX