User's Manual

Onity HT24W / HT28 Smart Hardware • 121
Using the Revalidator
From the staff member's point of view, the revalidation process is very simple and
quick. In its idle state, the revalidator will display "Press any Key".
• To revalidate a master key, first press any key on the revalidator.
• The revalidator will then prompt the user to insert the card. If using a
magnetic stripe key, the stripe on the key should be facing upward and
on the left side of the keycard as you insert the keycard. If using a
smart card, the chip should be facing down as you insert the keycard
into the slot.
• Once the card has been inserted, do not remove the card until the
display prompts you to do so. If using a smart card, this process may
take a few seconds for the system to recover the card activity
information.
• If a message has been entered for this user, the screen will beep and
prompt the user to press enter to see the message. The message will be
displayed on the screen.