Operation Manual

60
Begin by setting the hour and “am” or
“pm” if using 12-hour format. Use the
Arrow button to scroll to the correct
hour.
Check am/pm if applicable. If incorrect,
continue to press the Arrow button
until the hour and “am” or “pm” are
correct. Press the OK button to
continue.
Setting Date and Time
After the language has been set, the meter will
display the factory-set time and date. If the date
and/or time are incorrect, follow these steps in
Set-up mode (see page 58, Entering Basic Set-up
Mode).
Use the Arrow button to scroll to
the correct minutes and press the OK
button
OK
.
If “am” or “pm” is not correct, press the Back button to
go back to the previous display and reset to the desired hour
and “am” or “pm” setting.
Basic Set-up
Date
Sep 15-02
Time
12:00 am
Basic Set-up
Date
Sep 15-02
Time 1
12:00 am
You can ONLY change “am” and “pm” when you pass 12:00.
If you use the 12-hour format, make sure “am” or “pm” is
correct when setting the hour.
OK