Operation Manual

Coding the Meter

Code numbers are used to calibrate the

OneTouch

UltraSmart

Meter with the

OneTouch

Ultra

Test Strips for accurate results. You

must code the meter before using it for the first time

and then every time you change to another vial of

test strips.

Insert a OneTouch

Ultra

Test Strip to

turn on the meter. Push it all the way

in until it will go no further. “OneTouch

UltraSmart” will appear on the display

briefly. The first time you turn the

meter on, three dashes [---] will appear,

showing that there is no code stored in

the memory. Follow Step 4 to code the

meter.

CAUTION: Matching the code on the meter and the code on

the test strip vial is essential to obtain accurate results. Each

time you test, check to make sure the code numbers match.

STEP 1

Enter the Code Mode.