SDS

Page 5 / 9
RD-0038OPP - Onetime Lightweight Spackling
Revision Date: 25-Sep-2013
Eye/Face Protection Use approved safety goggles or safety glasses. If necessary, refer to appropriate
regulations & standards.
Skin and Body Protection Skin: Wear chemical resistant rubber gloves for repeated or prolonged use.
Body: Not required w/ normal use.
Respiratory Protection Avoid breathing of dust. Avoid breathing of vapors, mists or spray. If concentrations exceed
exposure limits specified, use a NIOSH-approved supplied air respirator. If protection factor
exceeded, use self contained breathing apparatus (SCBA). A respiratory protection
program that exceeds OSHA 1910.134 & ANSI Z88.2 requirements should be followed
when conditions warrant respirator use. If dry sanding preferred, use approved
NIOSH/OSHA respirator.
General Hygiene Considerations Wash hands w/ soap & water before breaks & @ end of workday. Remove & wash
contaminated clothing prior to re-use.
Information on basic physical and chemical properties
Physical State Paste
Odor Threshold Not determined
emarks • Method
pH 7.0-10.0
Melting Point/Freezing Point
~ 0 °C / ~32 °F
Boiling Point/Boiling Range ~ 100 °C / ~212 °F
Evaporation Rate Not determined
Ceta Closed Cup
Flammability (Solid, Gas)
Not determined
Upper Flammability Limits Unknown
Lower Flammability Limit
Unknown
Vapor Pressure Not established
Vapor Density
Heavier than air
Specific Gravity ~0.40-0.60 @ 25 °C (77 °F)
Water Solubility
Soluble in water
Solubility in other solvents Not determined
Partition Coefficient
Not determined
Autoignition Temperature Not determined
Decomposition Temperature
Not determined
Kinematic Viscosity Not determined
Dynamic Viscosity
Not determined
Explosive Properties Not determined
Oxidizing Properties Not determined
VOC Content (%) 0.5%
VOC Content < 10 g/L
Reactivity
Not reactive under normal conditions.
Chemical Stability
Stable under recommended storage conditions.
10. STABILITY AND REACTIVITY
Odor
Mild Acrylic/slight
ammoniacal
Appearance
White paste
9. PHYSICAL AND CHEMICAL PROPERTIES
Color
White
Property
Note: The information below is not
intended for use in preparing
product specifications
Flash Point
> 93.33 °C / > 200 °F