Users Manual

15/20 OTX-18.US Datasheet Rev H
Regulatory Information
10.1 FCC
10.1.0 List of applicable FCC Rules:
The device OTX-18 complies with Part 15 of the FCC Rules (47 CFR Part 15 Subpart C
§15.247). The device meets the requirements for modular transmitter approval as detailed in
FCC public Notice DA00-1407.
10.1.1 Specific operational use conditions:
The modular transmitter should be used within the limits outlined in Chapter 5 (Specifications)
and the according the Design Guidelines (Chapter 7).
Transmitter Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This device generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
■ Consult the dealer or an experienced radio/TV technician for help
CAUTION:
The FCC requires the user to be notified that any changes or modifications made to this device
that are not expressly approved by Onethinx BV may void the user's authority to operate the
equipment.
10.1.2 Limited module procedures:
N/A (the modular transmitter is approved as a ‘full modular module’).
10.1.3 Trace antenna designs:
N/A (the modular transmitter trace antenna is fixed on the PCB and therefore not applicable
for design considerations by the OEM integrator).