Specification Sheet

Table Of Contents

STEP 4

Attach the right (3) and left (4) armrests to the seat cushion (2)

using two screws (C) each. Do not fully tighten the screws. These

will be tightened after the back cushion is attached.

STEP 2

Align the seat plate (5) over the pre-drilled holes under the seat

cushion (2) (NOTE the position of the seat plate handle to the seat

cushion FRONT arrow). Attach the seat plate (5) to the seat

cushion (2) using two scre

s (A) and two screws (B) as shown.

Tight

securely with the allen wrench.

STEP 1

Insert the casters (8) into holes of the star base (7). Insert the

seat post (6) into the center hole of the star base (7).

STEP 3

NOTE: To install casters, apply

pressure to base of caster

using your thumb as shown

Turn the seat cushion so that it is upright. Position the center hole

in the seat plate (

) over the seat post (6). Then carefully lower

the chair onto the seat post.

ASSEMBLY INSTRUCTIONS

Front