ASSEMBLY INSTRUCTIONS MODEL 50-JN23BK8 SUPPLIER CODE: JNFF RUSTIC INDUSTRIAL LOCKER BOOKSHELF CUSTOMER SERVICE For fastest service on claims, requests for replacement parts, or questions, please visit our website at: www.comfortproducts.net/support e-mail: customerservice@comfortproducts.net Keep your sales receipt as documentation of your ownership.
PARTS LIST Overview Please look for part indicator on the side of the part. It is either stamped or on a labeled sticker.
PARTS LIST Please look for part indicator on the side of the part. It is either stamped or on a labled sticker.
HARDWARE KIT Stock # 51-JN23BK8HA 1 8 Cam Bolt & Lock Set Wood Peg x36 2 x32 9 Door Pin 4x14mm x4 3 x6 10 Nail Bracket x25 x4 4 11 7x50mm Screw Washer x2 x2 5 12 4x18mm Screw Door Handle x2 x4 6 13 Door Magnet Anchor Strap x2 x4 7 Wall Anchor 14 x1 4x32mm Screw x1
ASSEMBLY 1 2 Start by inserting Pegs into all the following wood pieces: Insert Pegs into the Roof (B) and Cabinet Floor (K). Then attach the related Trim pieces using a Cam Bolt & Lock (1).
3 Attach the Door Magnets (11) to the Cabinet Top (D) using two 4x14mm Screws (4) each. 4 Attach the Door Handles (10) to the Doors (H and F) using two 4x18mm Screws (9) each.
5 Attach the Cabinet Top (D) to the Divider (E) using two 7x50mm Screws (7). Sit the Roof (B) on top of the Divider using the pegs. Connect the Left Shelves (L) using Cam & Bolt locks (1).
6 Attach what you assembled in the previous step to the Left Wall (A) using Cam Bolts & Locks (1). Hang the Doors (F, H) between the Cabinet Top and the Cabinet Floor using door Pins (3), two for each door. 3 Use a washer (8) between the bottom Door Pin (3) and the Cabinet Floor. B M L L D 3 8 NOTE: You will use twelve Cam sets in all for this step. The following pieces each get two: B, L, L, D, K.
7 Screw twelve Cam Bolts (1) into the Right Wall (J) and four into the Divider (E). Then insert Cam Locks into the bottom of the Right Shelves (C). Set the Right Shelves onto the Bolts in the Divider and tighten the locks. Then attach the Right Wall in the same manner.
8 Tack the back panels on with nails (6) following the pattern shown below.
• • • • DO NOT stand on the table. Do not use the table as a stepladder. table Every 6 months, check all bolts and screws to ensure they are tight. This products is California 93120 Compliant for Formaldehyde. PLEASE VISIT WWW.COMFORTPRODUCTS.NET FOR WARRANTY INFORMATION Comfort Products warrants this product to be free from defects in material and workmanship for one (1) year.
