Hardware Manual
Table Of Contents
onesc
re
e
nso
lu
t
i
ons.
c
om
|
+1
858.552.0290
|
U
n
i
t
ed
S
t
ate
s|
Pa
k
i
st
an
|
Colom
bi
a
|
Mexico
|
UA
E
6
4. Getting Ready!
4.1. Installing the Wall mount
For mounting the unit, check the integrity of the wall, whether it can endure the load of the unit. After that,
clean the surface on which the unit is to be installed. Make sure your technician has the proper tools to install
the wall mount (these include screws, washers, drill machine, screwdriver etc.)
Follow the steps given below:
At least two persons are required to lift the screen.
Hang the horizontal mount with sufficient number of screws.
Check the level of the mount and make sure that it is properlyadjusted.
Attach and screw the mounting arms on the back side of unit properly, make sure that screws do not
damage the screen.
Hang the screen with the help of others and make sure that the mounting arms properly align and
fix themselves on the mount.
Make sure that spacing between wall and screen is 5 cm or more for proper ventilation.
Finally, place a little force downward and sideways to check whether the mount withstands the
forces.
The following figure shows the mounting arms and horizontal wall mount:
Mounting arms
(to be placed at the back of the screen using
screws)
Horizontal mount
(to be placed on the wall with screws)
Note: It is recommended that you reinforce the wall to bear the load of the unit.
The VESA mount pattern for the 55" unit is 400 x 400
The VESA mount pattern for the 65" unit is 400 x 400
The VESA mount pattern for the 75" unit is 600 x 400
The VESA mount pattern for the 86" unit is 600 x 400
The VESA mount pattern for the 98" unit is 600 x 400