Warranty
Page 2
SAFETY WARNINGS – PLEASE READ
Before Purchasing or Installing a dust collection system the buyer is cautioned to do so in accordance with
prescribed Federal, State, Local, OSHA, NFPA, and any other applicable codes or regulations relating to
the type of dust(s) you are collecting.
SOME TYPES OF DUST UNDER CERTAIN CONDITIONS HAVE THE POTENTIAL TO BE EXPLOSIVE.
Oneida Air Systems is not responsible for how the dust collector is used or installed. Dusts with
deflagration or explosion risks, such as wood dust, may require additional safety equipment including but
not limited to; venting, spark detection, suppression systems, back draft dampers or may require
installation in an outside location or in a protected area away from personnel. The customer assumes the
responsibility for contacting their insurance underwriter with regard to specific engineering controls or
application requirements. (We suggest you reference NFPA 664, 654 and 68 codes for more information)
Oneida Air Dust Collection Systems may not be suitable for some applications and are not designed to be
used in explosive atmospheres.
Oneida Air Systems equipment should only be installed and wired by a licensed electrician following all
applicable local and national electrical codes.
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains
chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
Lead from lead-based paints.
Crystalline silica from bricks, cement and other masonry products.
Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well ventilated area, and work with approved safety equipment,
such as those dust masks that are specially designed to filter out microscopic particles. Oneida Air Systems
recommends using additional approved safety equipment such as an approved OSHA and NIOSH dust
mask or respirator.
Oneida Air Systems makes every effort to accurately represent our products, specifications and prices;
however Oneida Air Systems reserves the right to make changes to products and prices at any time. As a
manufacturer, Oneida Air Systems reserves the right to change product designs and specifications at any
time.
Additional safety equipment such as but not limited to; spark detection systems and back draft dampers
and codes may require location of dust collection equipment in areas where no personnel are located.
Some types of dust are explosive. Oneida Air Systems is not responsible for how the dust collector is used
or installed. Before purchase and use of Oneida Air Systems products please review all national & local
codes regulations, and to be sure that Oneida Air Systems products will be installed and used in
compliance with all applicable safety codes. The buyer is cautioned to install and operate Oneida Air
Systems dust collection systems and products in accordance with prescribed Federal, State, Local, OSHA,
and NFPA, codes and regulations.