Product Manual
7.
Possible Ways to Attach Dust Deputy® to Shop Vacuums
You may want to attach your Dust
Deputy to your shop vacuum for mo-
bility, convenience or stability. There
is no denitive way to attach the Dust
Deputy to a shop vacuum. It will vary
with vacuum type and intended use.
These are just a few examples of pos-
sible ways it may be done.
Note: For better mobility and stability use the included 3 casters as shown
in the assembly instructions.
To prevent tipping, install
provided casters.
Some vacuums may only require
one foam block to attach the
bucket. This may be determined
by vacuum body shape.
Cut the provided foam block in half. Drill
two 1/4” holes through bucket, blocks and
vacuum as shown, then using provided
long bolts, washers and nuts, attach
bucket to vac.
Cut the provided foam block to size.
Drill two 1/4” holes through bucket,
blocks and vacuum as shown, then
using provided long bolts, washers
and nuts, attach bucket to vac.
The mounting is only limited by your
imagination.
Use the foam blocks as spacers
between the vac and bucket then put
the assembled Dust Deputy into the
attached bucket to hold it securely to
the vacuum. Attach the appropriate
hoses and you’re ready to go.
Use the foam block as upper spac-
er between the vac and bucket then
put the assembled Dust Deputy
into the attached bucket to hold it
securely to the vacuum. Attach the
appropriate hoses and you’re ready
to go.
8.
Assembly Instructions (Cont.)
If hoses are not tight on the inlet, or keep
pulling off, use the included Hose Reten-
tion Ring or the included clamp or both as
shown below.
Hose Retention Ring Hose Clamp
Make sure larger
diameter hoses are
pushed up so they t
tightly over the inlet