Product Manual

5.
10.
Adding Cyclones to Improve Performance
Attach in Series
Increases particle efciency.
Top View
This arrangement may be useful
for very ne dust situations.
Attach in Parallel
Same particle efciency
but increases CFM.
Multiple Vacuums
More Airow to Big Tools.
More CFM.
100 CFM 100 CFM
200 CFM
Your arrange-
ment is only
limited by your
imagination!
Top View
Top View
2 or More
- Table Saw
- Jointer
- Planer
Assembly Instructions (Cont.)
4.) Position foam block on marks and drill two holes
(upper and lower) through foam block and bucket
(Fig.6). Put the two supplied carriage bolts through
the large washers and then through the bucket from
the inside.
5.) Mark on shop vacuum where bolts will go
through (Fig. 7).
6.) Carefully drill through wall of vacuum (Fig. 8).
If you ever want to remove the Dust Deputy from
your shop vacuum, you can easily seal the holes in
your vac with a bolt, washer, nut and silicone if you
desire.
7.) Put bolts through the holes in vacuum and
fasten inside of shop vacuum body with another
washer and bolt as shown in Fig. 9.
Fig. 6
Fig. 7
Fig. 9
Inside shop
vacuum
Fig. 8