Product Manual

4.
11.
Troubleshooting
To Prevent Hose Pull Off
Accessories
Dust Deputy® not separating well. (Only a tiny amount of dust should
reach the vacuum.)
Wrap the inlet and outlet of the Dust Deputy with a layer of electrical tape
to increase the friction t.
Use a hose clamp.
Secure with a sheet metal screw.
Low air volume.
Material swirls in cyclone and won’t drop down into drum.
Hose connections not tight.
Air leak. Check cyclone ange / drum lid / barrel. Even small leaks
will affect performance.
Vacuum lter clogged. Blockage in hose.
Air leak in bottom of cyclone / drum lid or dust drum.
Large, bulkier material might swirl. Restart or temporarily cut off air
ow to drop material down.
Due to the varied hose diameters, exible couplers
can be used. They are available at local hardware
stores in the plumbing section.
The inlet and outlet of the Dust Deputy® are shouldered and tapered
to adapt to a range of vac hose sizes. If on your model the friction t
isn’t as tight as needed you can do the following:
SDD000002
Drum Dolly
Part # Description
Drum Dolly
Drum Dolly increases
Deputy’s mobility and
stability. Can be used
with either the 10 Gal.
metal or 5 Gal. plastic
drum.
AXS001160
YSS001160P
YSS006011P
Viper Scraper™
Extra Tungston Carbide Blade Set (3)
Extra Angle steel blade set (3)
Part # Description
Viper Scraper™
Hollow handle
scraper attaches
by hose to vacuum
source and sucks
debris through
handle to container.
Eliminates mess
from scraping that
usually falls to oor.
Assembly Instructions for Deluxe Dust Deputy® Kit
1.) Position drum so that lead caster
hole is drilled in bottom of bucket on
caution side as shown in Fig. 1. This
is so safety instructions are not cov-
ered up by foam block and are easily
read. Holes must be at least 1”
from bucket bottom rim so caster
can freely swivel (Fig. 2) when
unit is wheeled around. Use a
5/16” drill bit for holes. Drill the holes
in a triangular pattern as shown in
diagram left and Fig. 3.
(You’ll want to drill an extra hole in
the bottom to make it easier to pull
out second bucket for emptying.)
2.) Put casters through bottom of bucket and fasten with the pro-
vided washers and 1/2” hex head nuts as shown in Fig. 4.
Use the provided 14mm Thin Wrench to hold the hex nut on the
caster’s stem while tightening the nut inside of the pail.
Fig.1
Fig. 3
Fig. 4
Nut &
Washers
OAS
Label
1”
For
Clearance
Caution
Label
Caution
Label
Inside of Drum
Example 1
Fig. 2
3.) Wheel the bucket up to your shop vacuum and see where
the best placement for foam block will be on your vac. Use
the Foam Block template on page 14 to mark where block will
attach on your vacuum and bucket as shown in Fig. 5. You
should attach bucket to the side of vacuum opposite the
vac inlet. See Example 1 above.
Fig. 5
This is just one example of attaching the Deluxe Dust
Deputy® to a shop vacuum. Most shop vacuums will
use similar steps but you may have to modify slightly
for your particular vacuum.
For oversized vacuums, side
mounting of the Dust Deputy
kit may be necessary.
*Hose
not
included.
Angle Blades
Flat Blades