User's Manual

Part Number 110449
Revision Date: January 18, 2011
Magswitch E50 900/660 CE w/Remote
Operating Instructions cont’d
Releasing the load remotely “OFF”(Must Have External Antenna Installed)
o Ensure target is settled and lift ring is has slack
o Press the release sequence on the remote control once: OFF > ON > OFF
o LOOK for amber lights to begin flashing
o WAIT Three seconds
o LISTEN for motor sound
o LOOK for amber lights to become inactive
o TEST small lift to ensure target is fully released
Releasing the remote manually “OFF”
o Ensure target is settled and lift ring is has slack
o Press the release sequence on the lifter once: OFF > ON > OFF
o LOOK for amber lights to begin flashing
o WAIT Three seconds
o LISTEN for motor sound
o LOOK for amber lights to become inactive
o TEST small lift to ensure target is fully released
Before attempting any troubleshooting, verify load is secured in a safe condition.
If the E50 900/660 CE malfunctions and cannot deactivate, immediately cease operations with this magnet assembly. Follow the steps outlined below
to deactivate the magnet. If problems persist, please call 303-468-0662 for help with further troubleshooting or servicing.
Troubleshooting Deactivation
o Check that load completely settled and lift ring is in lowest position
 Lower cable for additional slack
o If using remotely, attempt to deactivate device with buttons on the lifter
 Replace remote batteries if needed
o Turn power to unit off, wait 10 seconds, turn power to unit on
 Check that power button is solid green, replace battery if necessary
Manual Release Operation
o Ensure target load is settled and lift ring has slack
o Remove the manual actuation pin by pulling up vertically on the black knurled cylinder next to the indicator light dome
o Screw manual actuation lever into Manual actuation lever attachment point
o Ensure lever is completely screwed in
o Depress the override button (silver) with one hand and rotate the lever 180 degrees counter clockwise with the other.
o The magnet should now be deactivated.
o Release the override button
o Unscrew the lever and replace in the storage sleeve
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.