User's Manual
Part Number 110449
Revision Date: January 18, 2011
o DO NOT leave a lifted load unattended at any time.
o Lifting Magnets must be centered on load. Or use spreader bars and two lifters for steel loads over 8’ in length. Refer to above section.
o User and anyone else in proximity must stay clear of the suspended load.
o Always ensure that the full face of the Magnet is in contact with the load. Maximum lifting capacity will only be achieved when the full
face of the magnet is in contact with the load being lifted.
o Not recommended for painted or finish coated surfaces as these will reduce the magnetic bond and the finish may be damaged.
o Always ensure that the lifted materials will not come in to contact with any obstruction while being carried.
o Never carry people or allow people to ride on materials being lifted.
o This product contains PTFE lubricant. For MSDS information contact Magswitch.
o Each Unit comes with a charger and two batteries. Use the charger only in the approved voltage capacity. We recommend you keep one battery in
the charger at all times.
DeRating the Rated Load Capacity
Numerous factors can negatively affect the strength of the Magnetic bond, dirt, debris, oils and grease, painted surfaces and any gap
between the Magnet and the metal surface will decrease the bond.
Additional factors include the type of Metals being lifted.
Shown below is a Typical DeRating Chart, it shows how different metals are attracted to a Magnet. Your results Will be Different
depending on such conditions as;
o Surface Condition
o Surface Flatness
o Surface Smoothness
o Material Thickness
o Material Flex Or Sag (May Require A Spreader Bar).
o Percentage of Magnet in Contact.
o And Other Conditions.
After the Lift
o Always check Lifting Magnet to ensure that no damage occurred and that is still complies with all requirements above.
o Always wipe off any debris or contaminants that became attracted to the Magnet that would prevent a safe lift in the future.
o Always notify the designated person in your company of any problems or concerns regarding the operation of the Magnet.
o Always store the Magnet in a safe location and in the “Off” position to ensure that no damage can occur or accidental contact with metal
be made. Ensure that the storage area is free of humidity, debris, shavings etc.
o Wipe a light coating of oil on the Magnet as needed to prevent rust.
o For safe operation, the bottom surface of the Magnet must always be Flat and Smooth. If necessary, it is possible to sand the Magnet face
smooth using 400 grit sandpaper and a flat surface. Always file any burrs that would interfere with full contact.
For repair and recertification services: Send the magnet, postage paid, to:
Magswitch Technology Inc. 8774 Yates Dr. #140, Westminster, CO 80031
Magswitch Limited Warranty
Magswitch products are covered by a One Year Limited Warranty on Material and Workmanship. Warranty is Non-Transferable.
Magswitch reserves the right to inspect all product claims under warranty. Any alteration of the device voids this warranty.
User assumes all risk for the proper use of this device and for ensuring product suitability for intended application.
This warranty shall not cover any incidental or consequential damages due to the improper use or failure of this device.
All Magswitch products are covered under International and U.S. Patents 6,707,360 & 7,012,495. Add’l patents pending.
Reduction factors for Materials
Other than AISI 1020 Steel
Material
REDUCTION FACTOR
Cast Steel
0.90
3% Silicon Steel
0.80
AISI 1095 Steel
0.70
416 Stainless Steel
0.50
Cast Iron Non-Chilled
0.45
Pure Nickel
0.10