Operator's Manual

6— English
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 9.
To install:
Removethefourcotterpinsthatsecurethetruckbody
totheframe.
WARNING:
CHOKING HAZARD.Smallparts.Keepoutofthereach
ofchildren.Adultsupervisionrequired.
Removethetruckbodyandsetaside.
Makesurethelatchesoneachsideofthebatterypack
snapintoplaceandthebatterypackissecuredinthe
productbeforereplacingthetruckbodyandbeginning
operation.
Setthetruckbodyontotheframe.Insertthecotterpins
andmakesurethebodyissecurelyinstalled.
To remove:
Removethefourcotterpinsthatfastenthetruckbody
totheframe.
WARNING:
CHOKING HAZARD.Smallparts.Keepoutofthereach
ofchildren.Adultsupervisionrequired.
Removethetruckbodyandsetaside.
WARNING:
HOT PARTS.Electricmotorandothervehiclepartscan
causeburnsaftervehicleoperation.Allowtimetocool
beforetouchingmotorareaandotherparts.
Depressthelatchestoremovethebatterypack.
Setthetruckbodyontotheframe.Insertthecotterpins
andmakesurethebodyissecurelyinstalled.
Forcompletecharginginstructions,seetheoperator’sman-
ualsforyourbatterypackandcharger.
ON/OFF SWITCHES
See Figure 2, page 9.
BoththetruckandcontrollerhaveanON/OFFswitch.
Thecontrollerswitchislocatedonitshandle.Thecontroller’s
LEDglowswhenitisturnedON.
The truck ON/OFFswitchislocatedontheundersideof
thetruck.
AlwaysturnbothswitchestotheOFFpositionbeforeremov-
ingorchangingbatteries,orwhenthetruckisnotinuse.
USING THE CONTROLLER
See Figures 3 - 4, page 10.
Thecontrollerispoweredby2AAAbatteries.Youwillneed
toinstallthe2AAAbatteriesbeforeusingthecontroller.
Alwaysturntheswitchesforthetruckandthecontrollerto
the OFFpositionwheninstallingthebatteryinthecontroller.
UsingaPhillipsscrewdriver,loosen screwholdingthe
batterycompartmentcoverinplace.
Liftthetabtoremovethebatterycoverfromthecontroller.
Install2 AAA batteriesaccordingto polarityindicators
(+or–)insidethebatterycompartment.
Replaceandsecurethebatterycover.
Whenthereisachargedbatterypackinthetruckandthe
ON/OFF switch is in the ON position, turning the controller
ONwillallowittopairwiththetruck.Youmaythenusethe
controllertodriveandsteerthetruck.
NOTE: Topairasecondtruckandcontroller,turnthesecond
truck switch ONandthenturnthesecondcontrollerswitch
ON.Repeatthissequenceforeachadditionalvehicle.The
truckwillpairwiththenearestcontrollerwhenitisturnedon.
Ifthetruckbecomesdifficulttocontrol,theAAAbatteries
mayneedtobereplaced.
STEERING TRIM ADJUSTMENT
See Figure 3, page 10.
Beforepullingthethrottletrigger,checkthesteeringtrim.
Thewheelsshouldbedirectedstraightahead,toprevent
thetruckfromveeringtotheleftorrightwhenthethrottle
triggerispulled.
Steeringtrimshouldbecheckedandadjustedperiodically
formaximumperformanceandcontrol.
Thesteeringtrimcanbeadjustedifthetruckveerstothe
leftorrightwhenyouaredrivingitstraightahead.
Setthetruckonaboxorblocksothatthewheelsdonot
touchtheground.Donottouchthewheelswhileyouare
makingadjustments.
If the truck is veering to the left:turnthetrimadjuster
totheright.
If the truck is veering to the right: turnthetrimadjuster
totheleft.
VARIABLE SPEED THROTTLE TRIGGER
See Figure 3, page 10.
Thevariablespeedthrottletriggercontrolsthespeedofthe
truckandforward/reversefunction. The moreyoupullor
pushthetrigger,themoreyouincreasespeed.
To drive forward: pullthethrottletriggerback.
To brake: pushthethrottletriggerforward.
To drive in reverse: pushthethrottletriggerforward.
STEERING WHEEL
See Figure 3, page 10.
Thesteeringwheelturnsthetruckrightorleft.Thefurther
youturnthewheel,thesharperthetruckwillturn.
Releasethewheeltogostraight.