Operator's Manual

6 – English
ADJUSTING THE VOLUME:
WhentheradioisturnedON,theunitwillreturntothelast
volumesettingused.
To increase the volume, press the VOLUME button
pointingupwards.
To decrease the volume, press the VOLUME button
pointingdown.
MODE SELECTION:
Press the MODEbuttontocyclethroughavailablemodes.
Therearefourmodestochoosefrom:
BLUETOOTH
®
mode
AUXmode
FMmode
AMmode
NOTE:Whenturnedon,theradiowillreturntothelastmode
thatwasusedifthebatterywasnotdisconnected.Inthe
eventpowerislosttotheradio,thedisplaywilldefaultto
BLUETOOTH
®
mode.
FM/AM TUNING:
The SCAN left and rightarrow buttons are used to tune
tothedesiredradiofrequency.Theselectedfrequencyis
displayedontheLCD.
 Press the MODE button until FM or AMisdisplayed.
 Pressandreleasetheleftarrowbuttontotunetoalower
frequency.Pressandreleasetherightarrowbuttonto
tunetoahigherfrequency.
Brieflypusheitherbutton(notpressandhold)totune
onefrequencystepatatime.
Todecreaseinterferenceorelectricalnoise,adjustthe
positionoftheantenna or move the radio to a higher
elevation.
NOTE: The SCANleftandrightarrowbuttonscanalso
beusedtoseekthenextavailablestation.
STORING A PRESET IN MEMORY:
Thememoryfeaturesavesupto20frequenciesaspresetsin
theradio’smemory.Youcansaveuptoten(10)frequencies
eachforFMandAMmodes.
TunetothedesiredFMorAMfrequency.
PressandholdthePRESETbuttonuntiltheword“PRE-
SET”andthepresetpositionnumberflashonthescreen.
Press the SCANleftandrightarrowbuttonstochoose
apresetpositionnumber.
NOTE:Thereareten(10)presetpositionsforFMand
ten(10)forAM.Onlyonestationcanbesavedineach
presetposition.
Press the PRESET buttonagaintostorethefrequency.
OPERATION
TO TUNE TO PRESETS (FM OR AM MODE):
PressandreleasethePRESET button to cycle through
eachpresetpositionnumberanditsassociatedfrequency.
EQUALIZER FUNCTION
To adjust the bass and/or treble settings:
 Press and hold the MODE button until the letter “b”
(BASS)andanumberisdisplayed.Pressagainandthe
letter“t”(TREBLE)andanumberisdisplayed.Thenumber
representsthecurrentsetting.
NOTE:Boththebassandtreblecanbeadjustedona
scaleof-5to5.
 Press the VOLUMEuporVOLUME downbuttonuntilthe
desiredbassortreblelevel(-5to5)isachieved.Press
MODE to store your selection.
NOTE:Ifanadjustmentisnotmadewithinapproximately
3seconds,thesettingscreendisappears.
USING A PHONE/MP3 PLAYER (NOT
INCLUDED) WITH THE RADIO
See Figure 3, page 9.
Press the MODE button until AUXmodeisdisplayed.
Connectauxiliarycable(notincluded)tothedevice.
Thephone/MP3playermustbeonandinplaymodefor
soundtobeheardthroughthespeakers.
Allphone/MP3playercontrolscanbeusednormallywhile
connectedtoradio.
NOTE: Volume for any device connected through the
auxiliarycablecanbeadjustedusingthevolumecontrol
forthatdeviceorbyusingtheradio’sVOL + or VOL –
button.
 TurningtheradiooffwillNOTturnthephone/MP3player
off.
 TheauxiliarycableDOESNOTprovidechargingfunction.
 For complete operating instructions for the connected
device,alwaysrefertothemanualthatwasincludedwith
yourdevice.
USING A BLUETOOTH
®
ENABLED DEVICE
(NOT INCLUDED) WITH THE RADIO
See Figure 4, page 9.
Press the MODE button until the BLUETOOTH
®
mode
ishighlighted.
WhentheradioisswitchedtoBLUETOOTH
®
mode,the
unitwillattempttopairtoaBLUETOOTH
®
enableddevice
and“BLUE”willflashintheLCDdisplay.
 NOTE:Theradiowillautomaticallyattempttoconnectto
thelastdeviceitwaspairedto.Ifaconnectioncannotbe
establishedwithinfiveseconds,theradiowillmakeitself
availabletootherBLUETOOTH
®
enableddevices.