User's Manual

33 - English
OPERATION
CHARGING A BATTERY PACK
See Figure 62.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use. If the garage door opener does not
charge the battery pack under normal circumstances, return
both the battery pack and garage door opener to your nearest
repair center for electrical check.
Connect the garage door opener to an AC power supply.
Install battery pack into the garage door opener as
described earlier.
Press on the battery pack to be sure contacts on the
battery pack engage properly with contacts in the garage
door opener.
The battery pack may become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
When the battery pack is fully charged, remove the battery
pack or leave it in the battery port to provide DC power
if needed.
INSTALLING MODULES
See Figures 63 and 64.
The garage door opener can power a variety of AC and
DC modules. For a complete list of modules, visit
ryobitools.com/garagehub.
WARNING:
Use only recommended accessories listed on our
website, in this manual, or in addendums. Use of
accessories that are not listed may cause the risk of
personal injury. Instructions for safe use of accessories
are included with the accessory.
WARNING:
Ensure modules are properly and securely connected to
their port on the garage door opener. Failure to properly
secure the module can cause it to fall and could result in
serious personal injury or property damage.
For DC modules:
Select one of the seven DC module ports to power your
DC module.
Hook the module to the top of the garage door opener
and insert it into the module port. Ensure the bottom latch
on the module is secured to the port on the garage door
opener.
NOTE: DC modules will not receive power unless the
module port has been activated. See Using the Indoor
Keypad later in this section.
DC
Module
Latch
Latches
Hooks
Hooks
Fig. 63
Fig. 64
AC
Module
Depress latches to release and remove the module.
For AC modules:
Remove both module port covers on the side where you
will install the module.
Insert AC module into the AC receptacle as shown.
Secure the module in place by hooking it to the top of the
garage door opener and ensure the bottom latch on the
module is secured to the port on the garage door opener.
Depress latches to release and remove the module.
NOTE: If the garage door opener is unplugged and a charged
battery pack is installed, the AC receptacles and DC module
ports will be disabled but the sensors and LED lights will
continue to function normally.
Module
Port # 1
AC
Receptacle