User's Manual

32 - English
OPERATION
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second is
sufficient to cause death or serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious death or personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualified service center for assistance.
For complete charging instructions, refer to the Operator’s
Manuals for your Ryobi One+ battery pack and charger
models.
NOTICE:
This product is designed to be powered by either a Ryobi
One+ 18V battery pack (DC mode) or by electric power
(AC mode). The unit will operate in AC mode whenever
it is connected to an electric power source. It will switch
to DC mode when an approved battery pack is installed
and the unit is not connected to an AC power source.
CONNECTING THE GARAGE DOOR OPENER
TO A POWER SUPPLY
See Figures 61 and 62.
For AC power:
Assemble and mount the garage door opener as
described earlier in the Installation section.
Connect the garage door opener to an AC power supply.
NOTE: Make sure the power supply is normal household
voltage, 120 volts, AC only, 60 Hz.
Ensure that the power cord does not droop excessively
or contact moving parts.
For DC power:
Unplug the garage door opener.
Open the battery door.
Insert the battery pack into the product as shown.
Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
WARNING:
Make sure the latches on the battery pack snap in
place and the battery pack is fully seated and secure in
the battery port before beginning operation. Failure to
securely seat the battery pack could cause the battery
pack to fall out, resulting in serious personal injury or
property damage.
Close the battery door.
Open the battery door and depress the latches to remove
the battery pack.
When a battery pack is installed and the power cord is
plugged in, the garage door operator will begin charging
the battery pack.
Fig. 61
Fig. 62
Battery
Pack
Battery
Door
Latches
Battery
Port
Power
Cord