User's Manual

5 — English
App images may vary.
OPERATION
TURNING THE INSPECTION SCOPE ON/OFF
See Figure 3.

To turn the device On, press and hold the power button
until the button starts to light up green (approximately 5
seconds).

The button should begin flashing within a few seconds.
When it stops flashing and turns solid green, the scope
is ready to connect.

To turn the device Off, press and hold the power button
for approximately 5 seconds until the button starts a
flashing red pattern. It will turn Off in a few seconds.
ATTACHING THE SMARTPHONE TO THE
INSPECTION SCOPE
See Figure 4.

Insert the smartphone into the clip and make sure it is
securely attached before use.
CONNECTING THE INSPECTION SCOPE WITH
YOUR SMARTPHONE
See Figure 5.

Turn the device On.

On your phone, turn the wireless network On and open
to the wireless connection screen.

Select the network named “PhoneWorksScope…” with
some trailing letters and numbers.

Once the phone indicates that it is connected to the new
network, go to the RYOBITM Phone Works
TM
App on your
phone.

Select and open the RYOBITM Phone Works
TM
App.

Open the INSPECTION SCOPE app segment. The video
feed should start within a few seconds.
NOTE: Your phone may not have internet access while it is
connected to the inspection scope.
AUTO SHUTDOWN
The inspection scope will turn Off if five minutes pass with
no connection from the RYOBITM Phone Works
TM
App.
Shutdown occurs when:
 The device is turned On but nothing is connecting to the
wireless network;

The device is turned On and a phone is connected to
the wireless network, but the INSPECTION SCOPE app
segment is not open;

The phone goes to sleep or the RYOBITM Phone Works
TM
App is sent to the background.
Fig. 3
ON/OFF
Fig. 4
Fig. 5