Operator's Manual

7 - English
INSTALLATION
ASSEMBLING THE FAN
 Remove the center nut from the motor assembly. Leave
the washer and stop nut on the shaft, and make sure the
stop nut is bottomed out on the shaft.

With the bossed side of the blade facing the motor as-
sembly, slide the blade through the outside of the motor
housing and onto the blade mount so the bosses fully
seat in the blade mounting holes.
CENTER
NUT
MOTOR
ASSEMBLY

Install the lock washers and blade screws and tighten to
secure the blade in place.
WASHER
 Repeat the above steps to install the remaining two
blades.

Install the LED light panel as shown, then replace the
center nut and tighten securely.
BLADE
MOTOR
HOUSING
BLADE
MOUNT
BOSSED SIDE
STOP
NUT
LOCK WASHERS
BLADE SCREWS
LIGHT
PANEL
CENTER
NUT
BLADE