Assembly Instructions

18 - English
OPERATION
To mount the remote control holder:

Remove the screw cover from the remote control holder.
 Install the remote control holder in the desired location
using the two mounting screws provided.

Replace the screw cover to cover the screw heads.
WARNING:
Always dispose of used batteries properly, includ-
ing keeping them away from children. Even used
cells may cause injury.
SCREWS
REMOTE CONTROL
HOLDER
SCREW
COVER
MODEL NO: CFARC03
FCC ID: VMZCFARC03 IC: 9880A-CFARC03
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY
CHANGES OR MODIFICATIONS NOT EXPRESSLY AP-
PROVED BY THE PARTY RESPONSIBLE FOR COMPLI-
ANCE. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following
two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
inter-ference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.