Assembly Instructions

7 - Français

INSTALLATION

ASSEMBLING THE FAN

 Remove the center nut from the motor assembly. Leave

the washer and stop nut on the shaft, and make sure the

stop nut is bottomed out on the shaft.



With the bossed side of the blade facing the motor as-

sembly, slide the blade through the outside of the motor

housing and onto the blade mount so the bosses fully

seat in the blade mounting holes.

 Install the lock washers and blade screws and tighten to

secure the blade in place.

 Repeat the above steps to install the remaining two

blades.



Install the LED light panel as shown, then replace the

center nut and tighten securely.

MOTOR

HOUSING

BLADE

MOUNT

BOSSED SIDE

BLADE

LOCK WASHERS

BLADE SCREWS

LIGHT

PANEL

CENTER

NUT

CENTER

NUT

MOTOR

ASSEMBLY

WASHER

STOP

NUT