Users Manual Part 2

15 - English
INSTALLATION
NOTICE:
The decorative arms in the next two steps are not
required for fan operation. You may skip these two
steps if you do not wish to install the decorative
arms.
 Install the decorative arms using a Phillips head screw-
driver. Attach one side of each arm to the center arm
support using the Phillips cap screws and screw covers
as shown.
NOTE: For easier assembly, insert each screw and par-
tially tighten, then go back and fully tighten each screw.
 Finish the assembly by screwing the finial screw on each
arm into the threaded holes in the top lens cover.
 Restore power to the room and wall switch, but do not
turn on the wall switch yet.
USING THE REMOTE CONTROL
WARNING:
Chemical Burn Hazard. Keep batteries away
from children. This product contains a lithium
button/coin cell battery. If a new or used lithium
button/coin cell battery is swallowed or enters
the body, it can cause severe internal burns and
can lead to death in as little as 2 hours. Always
completely secure the battery compartment. If the
battery compartment does not close securely, stop
using the product, remove the batteries, and keep
it away from children. If you think batteries might
have been swallowed or placed inside any part of
the body, seek immediate medical attention.
NOTE: If you have not already done so, restore power to
the room and wall switch, but do not turn the wall switch
on. The remote control will have no effect on the fan when
the switch is turned off.
DECORATIVE ARM
SCREW
COVERS
CAP
SCREWS
FINIAL
SCREW
DECORATIVE ARM