Operation Manual

WW W.ONEFORALL.COM 11
INITIAL
SETUP
ADVANCED
SETUP
LEARNING NOW!
PRESS ORIG.KEY
The Learning Feature
The URC-7780 comes with a complete library of pre-programmed codes. After you have
set up the URC-7780 for your device, you may find that there are one or more keys that
you had on your original remote, which do not have a place on the URC-7780 keypad.
As a convenience, the URC-7780 offers a special Learning feature that allows you to copy
any function from your original remote control onto the keypad of the URC-7780.
Before you start:
- Make sure your original remote control is working correctly.
- Make sure neither your URC-7780, nor your original remote control is pointing at
your device.
Learning
Example: To copy the “mono/stereo” function from your original TV
remote onto the A-key of your URC-7780.
1 Place both remote controls (the URC-7780 and your original) on a flat
surface. Make sure the ends which you normally point at your device are
facing each other. Keep the remotes at a distance of 2 to 5 cm.
2 Press and hold down MAGIC for about
3 sec. and...
will appear on the screen.
3 Press ARROW Right...
will appear on the screen.
4 Press ENTER 4 times…
will appear on the screen.
Use the ARROW keys to scroll
to the device mode in which you want
to place the learned function (e.g. TV).
5 Press the key (on the URC-7780
remote) where you want to place
the learned function (Example: A
key). The LED underneath the POWER
key will flash rapidly and...
will appear on the screen.
6 Press the key (on your original remote) that you want to copy on the URC-7780.
(Example: “mono/stereo” key). The LED underneath the POWER key will light up
twice to confirm that the function mono/stereo has been learned successfully onto
the A key.
NOTE: If you want to copy other functions within the same
mode, simply repeat steps 5
and 6 pressing the next key you want to copy by learning.
NOTE: If you want to copy other functions in a different
device mode, in step 4 select a
different device mode by using the ARROW Left / Right keys and continue with
steps 5 and 6.
NOTE: If the display reads LEARNING FAILED, press ENTER to start from “ADD
LEARNING” and press ENTER to continue with step 4.
NOTE: If the display reads MEMORY FULL you need to prioritise the functions you want
and delete the functions with the lowest priority
7 Press LIGHT once to go back to ADD LEARNING….or…. press and
hold LIGHT to exit programming mode.
- Use the LIGHT key to return to the previous screen.
- Press and hold down the LIGHT key to return to user mode.
ENTER
x4
SELECT MODE & KEY
RCV TV DVD
705057_7780_E_10t:12_Device_7780_Euro_10_Talen 07-05-2007 14:20 Pagina 11