User Guide

OWNER’S MANUAL
Re-assigning Device Keys 13
Learning (URC-6820 B00) exits the learning
mode.
PROGRAMMING A LEARNING KEY
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 7 5. The LED will blink twice.
3. Press a device key once (e.g., TV) to
assign a mode for learning.
4. Press the desired key once (e.g., +100)
to store a feature to be learned. The
LED will turn on and remain on for 5
seconds. If the LED does not turn on,
go back to step 1 and start again.
5. Place your original remote control
(e.g., TV remote control) head-to-head
(about 2" apart) from the One For All
6L Universal Remote Control with
Learning (URC-6820 B00).
6. On your original remote control, press
and hold the key (i.e., feature) to be
learned until the LED on the One For
All 6L Universal Remote Control with
Learning (URC-6820 B00) turns off
and then blinks twice. If the LED does
not blink twice, repeat steps 3 through
6.
7. To learn functions onto other learning
keys (e.g., M1 and M2), repeat steps 3
through 6.
8. To lock in new feature(s) on the One
For All 6L Universal Remote Control
with Learning (URC-6820 B00), press
and hold SET until the LED blinks
twice, then release SET.
9. To test a learned feature, press a device
key (e.g., TV) once where the learning
mode was assigned. Then press the
learning key (e.g., +100) where the
learned feature is stored.
DELETING FUNCTIONS FROM THE LEARNING
KEYS
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 7 6. The LED will blink twice.
3. Press the device key once where the
learned feature is stored (e.g., TV).
4. Press the learning key (e.g., +100) to
be deleted twice. The LED will blink
twice after the second press.
5. To clear additional functions stored on
other learning keys, repeat steps 1
through 4 (in this section).
RE-ASSIGNING DEVICE
KEYS
You can set the One For All 6L Universal
Remote Control with Learning (URC-6820
B00) to control a second TV, SAT, DVD
player, or other device. For example, to
control a TV, a cable box, and two DVDs,
you will need to re-assign an unused device
key (i.e., VCR) to operate the second DVD as
follows:
1. On the remote control, press and hold
SET until the LED (red light) blinks
twice, then release SET.
2. Enter 9 9 2. The LED will blink twice.
3. Press DVD once, then press VCR once.
4. The VCR key is now ready to be
programmed for your second DVD. See
“Setting Up Your Components” on
page 7.
To re-assign other device keys to the VCR
key, repeat steps 1 through 4 by substituting
the sequence from the below chart:
To Re-Assign
Device
Perform Sequence
OFA 6L with Learning Owners Manual.fm Page 13 Thursday, February 17, 2005 1:10 PM