User Guide

ONE FOR ALL 6L UNIVERSAL REMOTE CONTROL WITH LEARNING
12 Programming Favorite Channel Scan
3. To stop scanning channels at any time,
press any key once.
PROGRAMMING FAVORITE
CHANNEL SCAN
In the TV, VCR, DVD or CBL/SAT mode, you
can store a list of up to 10 favorite channels,
in any order, that will be immediately
scanned when you press FAV (see “Using
Channel Scan” on page 11).
NOTE: Only channels of one mode can be
stored for Favorite Channel Scan.
1. On the remote control, press TV, VCR,
DVD or CBL/SAT once.
2. Press and hold SET until the LED (red
light) blinks twice, then release SET.
3. Enter 9 9 6. The LED will blink twice.
4. Use the keypad to enter a favorite
channel number (e.g., 031). Then press
SET once.
NOTE: If the original remote control required
pressing an ENTER key to change the channel,
also press the ENTER key after the channel
number (e.g., 0 3 1 ENTER).
5. If desired, repeat step 4 (in this
section) for each favorite channel to be
stored, up to a total of 10 channels.
NOTE: If you try entering more than 10
channels, the remote control will
automatically exit programming.
6. To exit programming, press and hold
SET for 3 seconds. The LED will blink
twice.
USING LEARNING
The One For All 6L Universal Remote
Control with Learning (URC-6820 B00)
includes a Learning feature so you can add
functions that are unique to your home
entertainment devices (e.g., DVD EJECT).
However, there are some considerations.
LEARNING PRECAUTIONS
• Your original remote controls must be
in working order for learning to work
properly.
• Learned keys are mode specific, so
each one can store a unique function
for each mode.
• Learned keys can be used in macros
(see “Using Macros” on page 9).
• Do not use the following keys for
learning: Device Keys, SETUP, FAV, or
Record (•) Key.
• Learning capacity is approximately 50
to 70 keys, depending on the code
being learned.
• If both learned and keymoved
functions are assigned to the same key,
the last programmed function is
stored.
• A learned function cannot be used as a
source for Keymover (see “Using
Keymover” on page 14).
• Certain device codes are not learnable
including multi-frequency types, some
high frequency ones, and other
unusual formats.
• For optimum learning, avoid high
levels of ambient light such as natural
sunlight or energy-efficient fluorescent
lights.
NOTE: Please have your original remote
controls handy before programming learning.
Be sure to press each teaching key within 5
seconds of the previous entry. Otherwise, the
One For All 6L Universal Remote Control with
OFA 6L with Learning Owners Manual.fm Page 12 Thursday, February 17, 2005 1:10 PM