User Guide

OWNER’S MANUAL
Installing The Batteries 7
INSTALLING THE BATTERIES
1. On the remote control’s back, push
down on the top of the battery cover
(where indicated by the arrows). Then
slide the battery cover out.
2. Obtain two (2) new AA alkaline
batteries. Match the + and - marks on
the batteries to the + and - marks in
the battery case, then insert the new
batteries.
3. Slide the battery cover back into place.
The tab should click when the cover is
locked.
4. If batteries are inserted correctly, the
Kameleon display will turn on when a
key is pressed. Test the remote control
by pressing POWER and observing the
IR Animation.
NOTE: When batteries are low, the Inner IR
segments will blink 5 times after each key
press. The remote will stop operating when
the batteries need replacement. The
permanent memory retention ensures that
your codes are stored permanently even
during battery replacement.
BEFORE USING THE
REMOTE
By design, the first key press will always
make the screen turn on but will not cause
the remote to take any action until a key is
pressed after the screen is on.
Keep this in mind when programming the
features of your OFA Kameleon
TM
6 Device
Hybrid Remote.
ADJUSTING THE DISPLAY
T he OFA Kameleon™ 6-Device Hybrid Remote
(URC-6690) has several ways to adjust the
display for your comfort and best use
.
ADJUSTING BRIGHTNESS
The OFA Kameleon™ 6-Device Hybrid
Remote (URC-6690) has five levels of
brightness adjustment and is set to the
middle setting at the factory. To increase or
decrease the brightness, perform the
following steps:
1. Press and hold SET until the two Inner
IR segments flash twice. The current
mode key will blink on and off during
programming.
OFA Kam 6 Hybrid Owners Manual.fm Page 7 Wednesday, March 30, 2005 3:09 PM