User Guide
OFA Kameleon™ 6-Device Hybrid Remote
20 Troubleshooting
PROBLEM:  No display when 
programming.
SOLUTION:  Display has turned off due to 
inactivity. Start programming 
again and do not pause while 
performing instructions.
PROBLEM:  During programming, the two 
inner IR segments display a 
long flash.
SOLUTION:  An invalid entry has occurred. 
Check the keys to be pressed 
and start programming again.
PROBLEM: IR sent animation is displayed 
when you press a key, but 
home entertainment device 
does not respond.
SOLUTION:  Make sure the remote control 
is aimed at your home 
entertainment device and is 
not farther than15 feet away.
PROBLEM: The unit does not control 
home entertainment devices 
or commands are not working 
properly.
SOLUTION: Try all listed codes for the 
device brands being set up. 
Make sure they can be 
operated with an infrared 
remote control. 
PROBLEM:  Tried Searching For Your Code 
method and still could not 
find a working code.
SOLUTION:  Perform Restoring Factory 
Default Settings on page 17. 
Then repeat Searching For 
Your Code on page 10.
 PROBLEM:  Cannot program a macro onto 
M1, POWER or other keys.
SOLUTION:  Make sure the total number of 
key presses being 
programmed is less than 15 
and that you are not trying to 
program a macro on an 
invalid key (Device keys, Set 
Key and Fav key).
PROBLEM:  Power macro does not execute.
SOLUTION:  Make sure to press and hold 
the POWER for at least three 
seconds to initiate Power 
Macro.
PROBLEM: Changing channels does not 
work properly.
SOLUTION: If original remote control 
required pressing ENTER or OK 
to change channels, press 
ENTER or OK on the remote 
control after entering the 
channel number.
PROBLEM: During learning, Inner IR 
Segments display a long blink 
after pressing and holding key 
to be learned.
SOLUTION: Memory is full or a bad 
capture has occurred. Avoid 
high-ambient light sources, 
such as direct daylight and 
fluorescent bulbs. Try 
readjusting positions of 
remote controls before 
performing the procedure 
again.
PROBLEM: Tried Search For Your Code 
method and still could not 
find a working code.
OFA Kam 6 Hybrid Owners Manual.fm Page 20 Wednesday, March 30, 2005 3:09 PM










