Owner's Manual

WWW.ONEFORALL.COM 19
Problem & Solution
P
roblem:
Y
our brand is not listed in
the code section?
The ONE FOR ALL does not
o
perate your device(s)?
The ONE FOR ALL is not
performing commands
properly?
Problems changing
channels?
V
ideo not recording?
The ONE FOR ALL does not
respond after pressing a
key?
The red LED does not blink
when you press
a key?
S
olution:
T
ry the search method on page 9.
A) Try all the codes listed for your
b
rand. B) Try the search method on
page 9.
You may be using the wrong code.
Try repeating the Direct Set-Up
using another code listed under
your brand or start the search
m
ethod over again to locate the
proper code.
Enter the programme number
exactly as you would on your
o
riginal remote.
A
s a safety feature on your ONE
F
OR ALL, you must press the Record
key twice.
Make sure you are using new
batteries and are aiming the ONE
FOR ALL at your device.
Replace batteries with 4 fresh, new
“AAA” alkaline batteries.
URC-3741_V1_INT_27mei10:URC-7720 TANGO 2 7 NEW_’05 27-05-10 14:18 Pagina 19