Owner's Manual

6 WWW.ONEFORALL.COM
--> If your device does not respond to the ONE FOR ALL after you
have tried all the codes listed for your brand.
-
-> The Search Method may also work if your brand is not listed at
a
ll.
The Search Method allows you to find the code for your device by scanning
through all the codes contained in the memory of the ONE FOR ALL.
Example: To search for your TV code:
1
Switch on your television (not on standby) and aim your ONE FOR ALL
a
t your TV.
2
Press and hold down the MAGIC key
(for approximately 3 seconds) until
the red LED (underneath the ON key)
b
links twice.
The red LED will blink once, then twice.
3 Press 9 9 1. The red LED will blink twice.
4 Next, press OFF.
- If you wish you may also search for your code using
another function than “OFF”. Simply choose between 0,
1, 2, 3, VOL+, PLAY, STOP or MUTE instead.
5 Aim the ONE FOR ALL at your Device. Now press CH+ over
and over, until your e.g. Television switches off.
- Everytime you press the CH+ key the ONE FOR ALL will
send out a POWER signal (the function you chose at step
4) from the next code contained in the memory.
- You may have to press this key many times (up to 150
times) so please be patient.
- If you skip past a code, you can go to the previous
code(s) by pressing the CH- key.
- Remember to keep pointing the ONE FOR ALL at your
Device while pressing this key.
6 As soon as your Device switches off, press the MAGIC
key to store the code.
- If your Device does not switch on pressing the ON key,
simply press the ON key, a number key or CH+ to switch your e.g.
Television back on.
Search Method
x2
3710_Euro_1230508_52+6:URC-7720 TANGO 2 7 NEW_’05 23-05-2008 16:33 Pagina 6