User Guide

OWNER’S MANUAL
Changing Volume Lock 15
NOTE: The following keys cannot be used as a
source or destination: TV, CBL, SAT, VCR, DVD,
CD, PVR, AUD, AUX1, AUX2, FAV, and SET.
PROGRAMMING KEYMOVER
For example, if your VCR does not have
volume control, you can map those keys
(i.e., VOL +, VOL -, and MUTE) from the TV
mode to the VCR mode as follows:
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 4. The LED will blink twice.
3. For the source mode, press TV once.
4. For the source key, press VOL + once.
5. For the destination mode, press VCR
once.
6. For the destination key, press VOL +
once.
7. The LED will blink twice, indicating
the keymoved sequence is correct.
8. Repeat steps 1 through 7 twice more to
map remaining volume control keys,
substituting VOL - and MUTE as source
and destination keys in steps 4 and 6.
Upon completion of the above procedure,
you can now use your One For All 10L
Universal Remote Control with Learning
(URC-10820 B00) to control the TV’s
volume and MUTE in the VCR mode, as well
as in the TV mode.
RESTORING KEYMOVED KEYS TO DEFAULT
S
ETTINGS
Restoring a Single Keymoved Key
1. Press a device key that has a keymoved
key.
2. Press and hold SET until the LED (red
light) blinks twice, then release SET.
3. Enter 9 9 4. The LED will blink twice.
4. Press the destination key twice (where
the keymoved key is stored). The LED
will blink twice.
Restoring All Keymoved Keys in a Single
Mode
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 4. The LED will blink twice.
3. Press the destination mode twice
(where keymoved keys are stored). The
LED will blink twice.
CHANGING VOLUME LOCK
The One For All 10L Universal Remote
Control with Learning (URC-10820 B00) is
set at the factory for independent volume
control of each selected device.
However, you may change the Volume Lock
setting to Global Volume Lock so that a
device’s volume will be locked to one mode
(e.g., to control TV volume in all other
modes). After that, if desired, you can
perform Individual Volume Unlock on a
selected device to set its volume control for
independent operation.
LOCKING VOLUME CONTROL TO ONE MODE
(GLOBAL VOLUME LOCK)
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 3 and then press any mode
key once (e.g., TV). The LED will blink
twice.
3. Now, when you press VOL +, VOL -, or
MUTE, the volume of the selected
device (e.g., TV) will be controlled
regardless of the mode you have
selected.
OFA 10L with Learning Owners Manual.fm Page 15 Thursday, January 27, 2005 1:34 PM