User Guide

OWNER’S MANUAL
Using Macros 11
To Operate Master Power Macro
1. After programming, point the remote
control at the devices and press POWER
for at least 2 seconds to sequentially
turn on (or off) your devices.
NOTE: When you press POWER for less than 2
seconds, a power command will only be sent
to the currently-selected device. This allows
you to still individually power devices on or
off.
2. Devices will turn on (or off) according
to your programmed sequence.
NOTE: The currently-selected device will
always turn on or off first, followed by the
remaining programmed sequence. After the
master power sequence has been completed,
the remote control will be set to control the
first powered-on device.
NOTE: If one or more devices does not have a
POWER key, the power off/on sequence may
be slightly delayed when the remote control
signals the device(s).This action is normal.
PROGRAMMING A MACRO ON A DEVICE KEY
In its default state, when you press a device
key (e.g., TV) on the One For All 10L
Universal Remote Control with Learning
(URC-10820 B00), the remote will switch to
that selected device. However, you can also
program a Macro onto the Device keys to
allow for additional functionality. For
example, if your devices are connected to a
receiver unit, you can program a Device
macro to switch the receiver's input to the
selected device.
To Program the Device Key Macro
For example, let's assume that your DVD in
connected to Input 3 of your receiver. You
can program a macro that will switch the
receiver's input to input 3 when you press
and hold the DVD key.
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 5. The LED will blink twice.
3. Press the DVD key once.
4. Press the AUD key (to select the
receiver).
5. Press digit 3 (for the input), and press
DVD (to return control to the DVD key).
6. To save the settings and exit the
program, press and hold SET until the
LED blinks twice, then release SET.
NOTE: You can program up to 20 functions on
the Device Key Macro. You can program a
device Key Macro onto any device key.
To Operate the Device Key Macro
1. After programming, point the remote
control at the receiver and press the
DVD key for at least 2 seconds. This will
switch the Receiver's input to input 3,
to allow you to view the DVD.
NOTE: When you press the device key (e.g.,
DVD) for less than 2 seconds, the remote will
only select the DVD mode but will not change
the Input on the receiver. This allows you to
still change modes while using the remote.
NOTE: After executing the Device Key Macro,
the remote will return to the DVD mode, to
allow the control of the DVD device.
CLEARING A MACRO
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 5. The LED will blink twice.
3. Select a macro key (e.g., M1, M2, M3
POWER or any device key) you want to
clear and press it once.
OFA 10L with Learning Owners Manual.fm Page 11 Thursday, January 27, 2005 1:34 PM