Universal Remote User Manual

16
,EARNING
Learning lets you copy one or more functions from your
ORIGINALREMOTECONTROLTOTHISREMOTE&OREXAMPLEIFYOUR
audio receiver remote has a key that this remote doesn’t
have, you can copy (or learn) that key from the original
remote to this one.
Before You Start
s 9OURORIGINALREMOTECONTROLSMUSTBEINWORKINGORDER
for learning to work properly.
s ,EARNEDKEYSAREMODESPECIlCSOEACHKEYCANSTOREA
unique function for each mode.
s ,EARNEDKEYSCANBEUSEDINMACROSSEEh5SING
Macros”).
s $ONOTUSETHEFOLLOWINGKEYSFORLEARNINGSETUP or
2ECORDs+EY
s ,EARNINGCAPACITYISAPPROXIMATELYKEYSDEPENDING
on the individual functions being learned.
s .OTALLKEYSCANBELEARNED3OMEREMOTESHAVEKEYS
that use commands that are incompatible with this
remote.
s &OROPTIMUMLEARNINGAVOIDHIGHLEVELSOFAMBIENTLIGHT
such as natural sunlight or energy-efficient fluorescent
lights.
NOTE: Please have your original remote controls handy
before programming learning. Be sure to press each
teaching key within 5 seconds of the previous entry.
Otherwise, this remote exits the learning mode.
4OLEARNFUNCTIONSFROMYOURORIGINALREMOTES
1. Press and hold the SETUP key until the blue ring flashes
twice.
2. Press 9 7 5. The blue ring flashes twice.
3. Use the device select keys to highlight the kind of device
YOUWANTTOUSEWITHTHELEARNEDFUNCTION&OREXAMPLE
if you want learn a function to use with your audio
receiver, select AUDIO.
4. Place both remote controls on a flat surface. Make sure
that the ends you normally point at your device are
facing each other. The remotes should be 1–2 inches from
each other.
1–2
inches
5. Press the key on the One For All SmartControl remote
you want to use for the learned function. The indicator
for the device you chose in step 3 flashes rapidly.
 &OREXAMPLEIFYOUWANTTOUSETHEREDKEYFORTHENEW
function, press the red key.
6. Press the key on the original remote you want to learn.
The blue ring on the One For All SmartControl remote
flashes twice to confirm that you’ve learned the function.
To copy other functions within the same mode, repeat
steps 5 and 6, using a different key on the One For All
SmartControl remote.