User's Manual

PSPT401

To install the battery

1. Align the battery’s exposed copper contacts with the battery

connectors at the bottom part of the battery compartment.

2. Insert the contacts side of the battery rst and then gently

push the battery into place. Replace the back cover.

Charging the Battery

New batteries are shipped partially charged. Before you start

using your device, it is recommended that you install and charge

the battery. Some batteries perform best after several full

charge/discharge cycles.

Note: Only the AC adapter and USB sync cable provided with

your device must be used to charge the device.

Connect the USB connector of the AC adapter to the sync

connector on your device, and then plug in the AC adapter to an

electrical outlet to start charging the battery.

As the battery is being charged while the device is on, a charging

icon appears in the title bar

of the Home screen. After the battery has been fully charged,

a full battery icon appears in the title bar of the Home screen.

Warning:

• Do not remove the battery from the device while you are

charging it using the AC or car adapter.

• As a safety precaution, the battery stops charging before it

overheats.