User's Manual

Polaroid Turbo 350
7
Environment
Packaging: To facilitate the recycling of packaging materials,
please obey the sorting rules instituted locally for this type of
waste.
Batteries: Spent batteries must be deposited at the designated
collection points.
The product: The crossed-out waste bin mark afxed to the
product means that it belongs to the family of electrical and
electronic equipment.
To promote the recycling and recovery of waste electrical and
electronic equipment (WEEE) and at the same time safeguard
the environment. Please follow your local regulations for proper
disposal.
1 Getting Started
1.1 Getting to know your touch phone
1.2 Installing the SIM card, battery, and storage card
You need to remove the back cover before you can install the
SIM card and battery. Also, make sure to always turn off the
power before installing or replacing the SIM card and battery.
To remove the back cover
1. Make sure your device is turned off.
2. Firmly hold the device with both hands and the front panel
facing down.
3. Push the back cover up with your thumbs until it disengages
from the device and then slide it up to remove.
To install the SIM card
The SIM card contains your phone number, service details, and
phonebook/ message memory.
1. Remove the battery if it is installed.
2. Locate the SIM card slot, and then insert the SIM card with
its gold contacts facing down and its cut-off corner facing out
the card slot.
3. Slide the SIM card completely into the slot.
Some legacy SIM cards may not function with your
device. You should consult with your service provider for
a replacement SIM card. There may be fees for this service.
To install the battery
Your device comes with a rechargeable Lithium-ion battery and
is designed to use only manufacturer-specied original batteries
and accessories. Battery performance depends on many factors,
including network conguration, signal strength, and usage
patterns.
Warning: To reduce risk of re or burns:
• Do not attempt to open, disassemble, or service the battery
pack.
• Do not crush, puncture, short external contacts, or dispose of
in re or water.
• Do not expose to temperatures above 60°C (140°F).
• Replace only with the battery pack designated for this product.
• Recycle or dispose of used battery as stipulated by local
regulations.
1. Align the battery’s exposed copper contacts with the battery
connectors at the bottom part of the battery compartment.
2. Insert the contacts side of the battery rst and then gently