Installation & Assembly

Assembly Instructions
List of Parts for Assembly of Garden Table:
No. Parts Qty
A
Table Top
1
B
Table Leg
3
C
Leg Support
1
D
Flat Washer
9
E
Spring Washer
9
F
Nut
9
G
Bolt M8
6
H
Stud M8*34
3
I Rubber Pad(Pre-installed) 3
J
Caps
9
Assembly Instructions
1.Place table top (A)
on a clean soft
surface.
2.Attach the table
legs(B) using the
stud(G) on the table
top,using washers and
nuts(D,E,F),Tighten
using a wrench and a
washer(as a one line
screw driver)(Fig1)
3.Attach the leg support (C) 4.Tighten the nuts(H)on 5.Adjust the pre-installed
to the table leg (B) using
the leg support© using a
Rubber pads(I)until the
studs(H),washers,and
small wahser(as a cross
table is level with the
nuts(D,E,F).Tighten the nuts
screwdriver),Turn the
ground (Fig.3).Upon
using the wrench.
table over and tighten all
completion of full assembly
DO NOT
of the nuts. and bolted up all screws can
over tighten(Fig.2)
DO NOT
over tighten be tightened. Then put the
caps(J) on the nuts.
Warning:1)Maximum load on the edge of the table is 5kg 2)The umbrella base max size is diameter 30cm,height 25cm
A
B
C
D
E
F
G
FIG.2
FIG.1
FIG.3
D
E
F
H
D
J