Assembly Instructions

PAGE 2 OF 2

ANTI - TIPPING KIT

PARTS IDENTIFICATION

A. CHEST 1 SET

HARDWARE IDENTIFICATION

1. SHORT SCREW 1 PC

2. LONG SCREW 1 PC

3. CABLE TIE 1 PC

4. L BRACKET 2 PCS

2 4

WALL

STEP 3

Place the chest into position so both mounting brackets are vertically in line. Lace the end of the restraint strap

through the larger hole in each mounting bracket. Bring both ends together and slide the flat end through the

locking end and draw it through until all slack is removed. Confirm that the strap is securely laced and locked.

This tip restraint must be attached to a wall

stud using long screw enclosed.

STEP 1

Attach a bracket securely to the back top rail

of the chest using short screw provided,

through the smaller hole.

STEP 2

Locate the other bracket on the wall over a wall stud

and two inches below the mounting bracket secured to

the back of chest. Attached to the wall stud using

the long screw provided, through the smaller hole.