Installation Instructions

7
RIDGE FOR PITCH BELOW 10/12
1
The Apron Piece is installed on
both sides of the roof to secure
waterghtness. At the verge, the
Apron Piece has to be cut on site
parallel to the last corrugaon of
the shingle.
2
At low pitches (below 4/12),
so fastening is recommended
in order to avoid the possible
deformaon of the Slim Cap.
5
Foam closures can be fastened
below the ridge piece, in order
to prevent birds or other animals
from entering the roof space.
6
Install Closure Strips. Install Slim
Cap over Apron Piece maintaining
proper overlap and fastening
schedule.
4
For pitches above 8/12, it is
necessary to cut the at part
above the corrugaons.
3
RIDGE FOR PITCH ABOVE 10/12
The Slim Cap can be used for pitches up
to 10/12. Above that limit, the Standard
Ridge piece should be used.
Verge Piece
1
Install Closure Strips. Install ridge
fastening through corrugaons.
Closure Strips
Standard Ridge
piece
2
Gap for venlaon
Gap for venlaon
Cut the Apron
Piece
Verge Piece
Verge Piece
Gap for venlaon
Overlap
Overlap
Slim Cap
Apron Piece
Soft xing
Closure Cap
Slim Cap
Run shingles to ridge. Leave gap
for venlaon if desired.
Closure Strip