Instructions / Assembly

ManualsBrandsOndura ManualsBuilding materialsOnduraPremium Closure Strip

BROWN

BLACK

ONDURA® makes installation fast

and easy for all types of projects

Q Will not rust or corrode

Q Installs over solid decking or purlins

Q Can be installed over shingles

Q Wind resistant to 120 MPH

Q Quieter than metal roofing

Q Does not radiate heat or cold

Q Lightweight

Q Easy to trim and install—no sharp edges

Q No special tools required

Q Lifetime Limited Warranty

Choice of colors:

ǁŝƚŚŝŵƉƌŽǀĞĚǁŝŶĚƉĞƌĨŽƌŵĂŶĐĞŝŶƐƚĂůůĂƚŝŽŶ

CorruCorruggaatteed Asphalt Rd Asphalt Rooﬁngooﬁng Sheets Sheets

I N S T A L L A T I O N I N S T R U C T I O N S

RED

GREEN

Summary of content (5 pages)

PAGE 1
Corruggated Asphalt Rooﬁng Corru Rooﬁng Sheets I N S T A L L A T I O N I N S T R U C T I O N S ONDURA® makes installation fast and easy for all types of projects Q Will not rust or corrode Q Installs over solid decking or purlins Q Can be installed over shingles Q Wind resistant to 120 MPH ǁŝƚŚ ŝŵƉƌŽǀĞĚ ǁŝŶĚ ƉĞƌĨŽƌŵĂŶĐĞ ŝŶƐƚĂůůĂƚŝŽŶ Q Quieter than metal roofing Q Does not radiate heat or cold Q Lightweight Q Easy to trim and install—no sharp edges Q No special tools required Q Lifetime Limite
PAGE 2
Thank you for choosing ONDURA® PREMIUM SERIES for your roofing project ONDURA® should be carefully installed. Mistakes during the installation can cause problems later and impact warranty. Please take the time to closely follow these installation guidelines. CAUTION Installation of roofing materials can be dangerous. The relative amount of danger typically increases as the steepness of the roof pitch and the height from the ground.
PAGE 3
INSTALLATION STAGE If possible, we recommend placing the first row of ONDURA® sheets on the roof to confirm coverage overlaps before installation of the sheets. Placement of ONDURA® Sheets If more than one row of ONDURA® sheets is needed, then the sheets must be installed along the eave first. Then additional rows are installed above the previous row. Fastener Positioning Genuine ONDULINE® Fasteners are recommended for use on all ONDURA® products.
PAGE 4
ONDULINE® Fastener Instructions Ridge Cap Drive ONDULINE® screws only through the crown of the corrugation and always perpendicular to the roof's surface. Be careful not to overdrive the screw. The rubber washer on the screw should snugly contact the panel without dimpling the sheet. When appropriately installed, slight hand pressure on an affixed corrugation should not separate the sheet from contacting the washer. Note: Install all sheets on both sides of the roof before installing the ridge cap.
PAGE 5
ADVANCED INSTRUCTIONS Handling Hips Valley Flashings For valleys, install a minimum 18-inch wide metal valley flashing. Cut sheets at an angle to fit the valley; then turn over, and on the undersides along the valley edge, caulk two corrugations of the ONDURA® solid closure strip, and place into the corrugation. Then put a ½-inch bead of caulking on the flat side of the solid closure strips and along the corrugation of the sheet between the solid closure strips.