Installation Guide

ManualsBrandsOndura ManualsBuilding SuppliesDuraline 3.66-ft x 3.29-ft Corrugated Black Asphalt Roof Panel

DURALINE™ CORRUGATED ASPHALT ROOFING SHEETS

QUICK START REFERENCE GUIDE

Drill-1/4”

Bit

Utility

Knife

Saw

Tape

Measure

Hand, Eye and Ear

Protection

Pencil

1) Starting at a lower corner place the eave closure strip on

the roof deck 1” up from the edge, then lay the Duraline

Sheet on the roof allowing 1”-1 ¾” overhang at the eave and

aligning the outside edge. Fasten the sheet at the eave from

the outside edge inward ensuring the fasteners penetrate the

closure strips as well to hold them in place (leave the last

fastener out to allow for side lap of the second sheet.)

2) Place the second closure strip and sheet on the deck in

the same manner, overlapping at least one corrugation and

maintaining a consistent overhang, until reaching the

opposite edge.

HINT: It may be helpful to layout the first row and adjust left to

right so both edges look the same.

Vertical Cutting

PREPARING FOR YOUR PROJECT

TOOLS REQUIRED FOR INSTALLATION

ESTIMATING MATERIAL

INSTALLING YOUR PROJECT

Duraline Sheet

10 SQ FT of

coverage per

sheet

Fasteners

5 per sheet (10 for

improved wind

performance)

8 per ridge cap

Closure Strips

Each pack covers

80" of eave and

40" of ridge

Ridge/Hip Caps

Each cap covers 36"

of Ridge or Hip

Optional Advanced Application Accessories:

Ondulair

Slim

lashing

and

Flexible

Pipe Boot

DURALINE is designed to be installed on solid decking a

minimum of 7/16” OSB and at a pitch of at least 3:12

(see below). For additional protection underlayment

and drip edge is suggested to prevent water infiltration.

Always refer to local building codes before starting any

project.

Summary of content (2 pages)

PAGE 1
DURALINE™ CORRUGATED ASPHALT ROOFING SHEETS QUICK START REFERENCE GUIDE PREPARING FOR YOUR PROJECT DURALINE is designed to be installed on solid decking a minimum of 7/16” OSB and at a pitch of at least 3:12 (see below). For additional protection underlayment and drip edge is suggested to prevent water infiltration. Always refer to local building codes before starting any project.
PAGE 2
INSTALLING YOUR PROJECT 3) For additional rows, stagger the vertical seams and install aligning the installation guides embossed into the sheet. Cut the last row off 1” short of the ridge. 4) Repeat steps 1-3 on the opposite side of the roof. Make sure fasteners are properly seated on the material. 5) Place the first ridge cap on the gable end of the roof overhanging 3”-4” and then place the ridge closure strips under the cap at least 1” from the bottom edge of the cap.