User's Manual

OnAsset Intelligence, Inc. | 8407 Sterling St.| Irving, TX 75063
Tel: [phone] | Fax: [phone]
www.onasset.com CONFIDENTIAL Page 7 of 8
The contents of this document are proprietary to OnAsset Intelligence, Inc. You may not distribute this document in whole or part in printed, electronic or in any other form to any
third party without prior expressed written consent by OnAsset Intelligence, Inc.
Weight
1.8 oz. (51g)
SENTINEL 100P OVERVIEW
The Sentinel 100P is a compact, battery-powered BLE sensor tag that can be used to
track and monitor an aircraft ULD.
To use the Sentinel 100P, follow the installation process below.
Communication
Bluetooth Low Energy v5.0
Battery
Two ER14050 lithium thionyl chloride batteries
Sensors
Shock / Temperature / Humidity / Light
Environmental
Operating Temp: -40°C to 85°C
Dimensions
64.5mm x 50mm x 13mm
Weight
1.8 oz. (51g)
Install the Sentinel 100P into the pallet using the following process:
SENTINEL 100B OVERVIEW
The Sentinel 100B is a BLE accessory for OnAsset’s SENTRY 500 FlightSafe®
cellular tracking device that enables a SENTRY to act as a gateway for other
Sentinel tags.
To use the Sentinel 100B follow the installation process below.
Place Sentinel 100P in cutout
section on pallet corner piece.
Slide Sentinel 100P tag into
extrusion rail on pallet.
Slide Sentinel 100P and corner
piece info pallet extrusion rail until
corner piece is flush.